Fly Agaric Embroidered Iron-On Patch

This patch is part of a collaboration set with Coral Nathan and was successfully funded through Kickstarter 🖤

• Iron on back
  
• Embroidered
  
• 120mm

To Iron-on:

1. Clean the item where you'd like to adhere the patch.
2. Line the patch up where you'd like it and place a cloth over the patch to protect when ironing.
3. Set the iron to a lower temperature and ensure the steam function is off. 
4. Iron the cloth-covered patch evenly for about 30-60 seconds with little movement of the iron as possible.
5. Turn the item inside out and repeat the process on the back of the patch to ensure a strong bond.
6. Allow the item to cool completely before checking the patch and if there are any lifting areas then repeat this process until the patch is fully bonded.

Packaging:

I am proud to say that all of the packaging I use is recyclable and/or biodegradable. 

• Boxes: cardboard (biodegradable and recyclable) 
• Tissue paper: acid-free (biodegradable) 
• Zig-zag filling: card (biodegradable and recyclable) 
• Backing cards: card (biodegradable and recyclable) 
• Pin bags: glassine (biodegradable and recyclable) 
• Packing peanuts: starch (biodegradable)
• Hive wrap: card (biodegradable and recyclable) 

Disclaimer: 

Embroidery Patches: Products are not for the ages of 13 and under. When ironed, the glue can become hot and burn and contains small components that could risk chocking if swallowed. 

Not suitable for materials like nylon (unless sewn), leather (unless sown) or stretchy fabrics.